Pleasant River 0022828 Installationsanleitung PDF herunterladen

Shiplap Siding Installation

To make sure your shiplap siding installation goes as quickly and easily as possible, here are

some general guidelines. Remember that these are guidelines only; you must consult your local

building codes or a professional siding installer in your area. Consulting your local building

department or HOA prior to starting exterior renovations to either a residential, or commercial

building is a required step in any project.

1. Apply a vapor barrier to the wall.

2. Attach 3/4" furring strips over the vapor barrier every 16".

3. Start at the bottom of the wall. To start the installation of a siding board pre-drill holes

above each furring strip with a 1/8" drill bit.

4. Drive a 3" stainless steel screw through the 1/8" pre-drilled hole in the last step. This will

secure the bottom half of each siding board.

5. Next, with a 1/8" drill bit predrill a hole through the narrow part of the siding board that

protrudes against the wall on the top of the board.

6. Drive a 3" stainless steel screw through the 1/8" pre-drilled hole in the last step. There is

no need to worry about plugging this hole as the next board that is installed will cover

this fastener.

7. Repeat the above steps for the rest of the siding boards up the wall.

Shiplap Siding Installation 1

Inhaltsverzeichnis

Seite 1 - Shiplap Siding Installation

Shiplap Siding Installation To make sure your shiplap siding installation goes as quickly and easily as possible, here are some general guidelines. Re

Kommentare zu diesen Handbüchern

Keine Kommentare

Pleasant River 0022828 Installationsanleitung

Stöbern Sie online oder laden Sie Installationsanleitung nach Nein Pleasant River 0022828 herunter. Pleasant River 0022828 Installation Guide Benutzerhandbuch

Inhaltsverzeichnis

Kommentare zu diesen Handbüchern